Single Station Vicat Test Apparatus
1.0360
28
Figure 24: Setting the Y-coordinate of samples center
One-time short press of the button increases the Y-value by about 0.1 mm.
The needle moves toward display.
If you keep this button pressed, the value continuously increases by the relevant proportion until either you
have released the button or you reach the maximum permissible value.
One-time short press of the button decreases the Y-value by about 0.1 mm.
The needle moves toward cleaner device.
If you keep this button pressed, the value continuously decreases by the relevant proportion until either
you have released the button or you reach the minimum permissible value.
To get the set value also after switching off the device press the button.
To Next Page
Loading...
