TESTING Vicat - Brush Replacement; Device Cleaner Brushes

Single Station Vicat Test Apparatus
1.0360
40
5.2 Replacing the brushes
Depending on the option, the device is equipped with a cleaning device for needle or cone.
When the brushes worns up, so that the needle can no longer be cleaned, they must be replaced.
Loosen the screws and pull out the brushes from the holders.
Insert new brushes and tighten the screws.
Figure 35: Replacing the brushes of device cleaner for needle
Note

The brushes can be turned into position by hand so that the screws
can be reached with the key.
Insert new brushes and tighten the screws.
Loosen these screws.