Texas Instruments DLP NIRscan User Manual

www.ti.com Operating Modes
2.1.2 Bluetooth Connection
To connect to the DLP NIRscan Nano, the Bluetooth circuits must first be powered. The following steps
activate the Bluetooth circuits:
1. Press the Scan/Bluetooth button and hold it for more than 3 seconds to power the Bluetooth circuits.
2. After the Bluetooth circuits are powered and active, the blue LED turns on and the DLP NIRscan Nano
advertises its presence through Bluetooth.
3. Run the iOS App and click the Scan button at the top-right of the screen. This will establish a
connection with the DLP NIRscan Nano. The Bluetooth icon on the top-right of the screen will flash.
4. After the DLP NIRscan Nano establishes connection, the blue LED will pulse to indicate that the
connection was successful.
19
DLPU030B–June 2015–Revised July 2015 Getting Started
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated

Texas Instruments DLP NIRscan Specifications

General

Brand	Texas Instruments
Model	DLP NIRscan
Category	Motherboard
Language	English