NIRscan Nano GUI
www.ti.com
3.1.3 Transferring Scans Stored in microSD Card
Whenever scans are taken by pressing the Scan button on the microprocessor board, the scans are
stored on microSD card, if one is present. To transfer the stored scan on microSD:
• On the Information Tab, under microSD card, click the Refresh button.
• This will read all the scans stored on the microSD card, and will report the number of scans detected
after "No. of unread scan Data", as shown in Figure 3-7.
• On the Scan tab, click the Scans button in the upper-right corner to display the previous scans. Scans
transferred from the microSD card will be listed with filenames starting with "scan" followed by a four
digit number, as shown in Figure 3-8.
Figure 3-7. Number of Scans Detected on microSD Card
28
Operating the DLP NIRscan Nano EVM DLPU030B–June 2015–Revised July 2015
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated
To Next Page
Loading...
