2.7
Initial System Checkout
After you’ve installed all internal options and external cabling, you’re ready for
system checkout and software configuration.
To check out the system, set the power switch on the notebook to the On (
I
) position
which initiates the notebook self test. During self test execution, the computer
checks the operation of all key hardware including memory and CPU (and displays
copyright and version number data during test execution).
Upon successful conclusion of self test, the computer automatically loads its
operating system and Windows environment. If self test fails to complete and an
error message is displayed, try powering down the computer for a couple of minutes
and turning power back on to repeat self test. If the error message persists, see
Section 6 for troubleshooting information.
2.8
Configuring the System
The first time you power up the notebook, it automatically runs the Setup Program
which prompts you for country name and printer type. You exit Windows and the
notebook begins unzipping files and preparing the software for use. Then it gives
you the option of keeping or removing the video.
Figure 2-10 AC Adapter Installation
2-12
Installation
To Next Page
Loading...
Need help?
General
