138
TMS320C6748
SPRS590G –JUNE 2009–REVISED JANUARY 2017
www.ti.com
Submit Documentation Feedback
Product Folder Links: TMS320C6748
Peripheral Information and Electrical Specifications Copyright © 2009–2017, Texas Instruments Incorporated
6.14 Serial ATA Controller (SATA)
The Serial ATA Controller (SATA) provides a single HBA port operating in AHCI mode and is used to
interface to data storage devices at both 1.5 Gbits/second and 3.0 Gbits/second line speeds. AHCI
describes a system memory structure that contains a generic area for control and status, and a table of
entries describing a command list where each command list entry contains information necessary to
program an SATA device, and a pointer to a descriptor table for transferring data between system memory
and the device.
The SATA Controller supports the following features:
• Serial ATA 1.5 Gbps (Gen 1i) and 3 Gbps (Gen 2i) line speeds
• Support for the AHCI controller spec 1.1
• Integrated SERDES PHY
• Integrated Rx and Tx data buffers
• Supports all SATA power management features
• Internal DMA engine per port
• Hardware-assisted native command queuing (NCQ) for up to 32 entries
• 32-bit addressing
• Supports port multiplier with command-based switching
• Activity LED support
• Mechanical presence switch
• Cold presence detect
The SATA Controller support is dependent on the CPU voltage operating point:
• At CVDD = 1.3V, SATA Gen 2i (3.0 Gbps) and SATA Gen 1i (1.5 Gbps) are supported.
• At CVDD = 1.2V, SATA Gen 2i (3.0 Gbps) and SATA Gen 1i (1.5 Gbps) are supported.
• At CVDD = 1.1V, SATA Gen 1i (1.5 Gbps) only is supported.
• At CVDD = 1.0V, SATA is not supported.
To Next Page
Loading...
Need help?
General
