Texecom Premier 888 - Arming and Disarming the System; To Arm the to Part Arm the System; System

P
rem
i
er
888
&
8168
U
ser
M
anua
l
Th
e
A
rm
i
ng
M
enu
INS177 9
Arming and Disarming the System
The system is Armed, when ALL areas that are controlled
by the User code, have been armed with ALL zones ON
(not omitted).
The system is Part Armed, when ALL areas that are
controlled by the User code have been armed with SOME
zones OFF (omitted) or SOME areas controlled by the
User code have not been armed.
!
The system is only Part Armed when zones are
omitted using the ‘Part Arm 1, 2 or 3’ procedure.
Omitting zones manually (see page 15 for details) is
not classed as Part Arming.
To Arm the System
➤ To arm the system, proceed as follows:
Ensure that the premises are secure (all doors and
windows closed etc.) and the Ready light is on.
To do a quick arm, press
%
%%
%
.
Or
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
#
##
#
, the exit tone will sound (if silent arm has not
been selected) and the display will look something like
this:
*+.'-#1 (#IJ1) #X
####*99 99999#
Leave the premises, when the system has armed the exit
tone will stop (if sounding).
The system is now armed.
To Part Arm the System
➤ To part arm the system, proceed as follows:
Ensure that the premises are secure (all windows and doors
not being omitted are closed) and the Ready light is on.
To do a quick part arm, press
'
''
'
.
Or
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
'
''
'
, the display will look something like this:
!"#$"%# &'()6H
IR.(1(L #*+,#K "<.
or
*+.'#*+ ,#A%1) .#3
####*99 99999
Use keys
!
!!
!
-
1
11
1
to select the required part arm or
area suite, the display will look something like this:
!"#$"%# &'()6H
U.<)1,. #*+,#3
or
*+.'#*+ ,#A%1) .#7
####*UB 99999
!
The bottom line of the display is programmable for
each Part Arm.
The top line of the display is programmable for each
Area suite.
When the required part arm or area suite has been
selected press
#
##
#
, the exit tone will sound (if silent arm
has not been selected) and the display will look something
like this:
*+.'-#1 (#IJ1) #X
####*99 99999#
Leave the protected area. When the system has armed,
the exit tone (if sounding) will stop and the display will look
something like this:
*+.'-#* +,.<#X
####*99 99999#
W##0*QM#*QKI!##W
#M%.#54#K'+#7553
The system is now part armed.