e
rm
ng
enu
rem
er
ser
anua
18 INS177
View Act. Faults
If any zones with the ‘Activity’ attribute have not been
activated within a certain time period, an activity fault will
be displayed at the time of arming. Users with access to
this function will be able to view the activity faults.
!
The system may have been programmed so that an
activity fault will not allow arming. If this is the case
the system can only be armed once the zone in fault
has been activated (forced walk test).
➤ To view activity faults, proceed as follows:
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
)
))
)
until the display looks like this:
!"#$"%# &'()#) "
=1.&#*> )9#?'% @)-
Press
#
##
#
, the display will look something like this:
F"(.#55 3#A.>% +.
?+"()#! ""+### ##X
Press
)
))
)
to scroll up and down through the zones.
!
Only zones with the ‘Activity’ attribute that have not
been activated will be shown.
When all the required zones have been viewed press
#
##
#
, the display should look like this:
!"#$"%# &'()#) "
=1.&#*> )9#?'% @)-
Press
(
((
(
to exit the menu and return to normal.
View Act. Counts
Users with access to this menu will be able to view the
number of activity faults that have occurred on each area.
➤ To view activity counts, proceed as follows:
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
)
))
)
until the display looks like this:
!"#$"%# &'()#) "
=1.&#*> )9#B"% ()-
Press
#
##
#
, the display will look something like this:
*>)1R1) $#*X#5 555
M")'@#B "%()#5 55:
Use keys
!
!!
!
-
1
11
1
to view specific areas i.e.
0
=
Area B or use the
)
key to search, the display will look
something like this:
*>)1R1) $#UX#5 55:
M")'@#B "%()#5 555
!
To reset the activity counter, press
(
((
(
.
Press
/
//
/
when finished, the display should look like
this:
!"#$"%# &'()#) "
=1.&#*> )9#B"% ()-
Press
(
((
(
to exit the menu and return to normal.