Texecom Premier 888 - To Reset an Alarm; User Reset; Engineer Reset; Anti-Code

Th
e
A
rm
i
ng
M
enu
P
rem
i
er
888
&
8168
U
ser
M
anua
l
14 INS177
To Reset an Alarm
Once the alarm has been silenced (see page 13 for
details), the system will need to be reset.
User Reset
➤ To reset the alarm, proceed as follows:
Enter a valid User code
....
........
....
, the display
should look like this:
0+.--#Q IAIM#) "
B@.'+#) C.#*@' +,
Press
(
((
(
to clear the alarm, the external strobe will
stop, the system will chime and the display will return to
normal.
!
If the system has been programmed, to be reset by
an Engineer, pressing
(
will not return the
display to normal. If this is the case, see Engineer
Reset for details.
The system may have been programmed to be reset
by Anti-code, if this is the case, see Anti-code Reset
for details.
Engineer Reset
If the system has been programmed to be reset by an
Engineer following an alarm activation, you will still be able
to silence the alarm by entering a valid User code (see
page 13 for details).
➤ To reset the alarm, proceed as follows:
F"(.#557#*@'+,
38684958N#M%.#54
MC.#E '@@&'$# 01+
Enter a valid User code
....
........
....
, the display
will look something like this:
B'@@#I( L1(..+ #)"
##Q.-.) #A$-). ,
!
The number of the zone that caused the alarm will
be displayed (in this case Zone 2) and the numbers
of any subsequent zones activated (if any) will be
alternated on the display.
Contact the telephone number on the display (if
programmed) or the telephone number at the rear of
this User Guide.
!
The area that the alarm occurred on cannot be
armed again until the alarm has been reset.
Anti-code Reset
If the system has been programmed to be reset using an
Anti-Code following an alarm activation, you will still be
able to silence the alarm by entering a valid User code.
➤ To reset the alarm, proceed as follows:
Enter a valid User code
....
........
....
, the display
will look something like this:
B'@@#*Q B#)"
Q.-.)#A $-).,
Press
(
((
(
, the display will look something like this:
^%").#X #8723
Q.N@$#X #HHHH
!
Where 4281 is the random code in this example.
Contact the telephone number on the display
(if programmed) or the telephone number on the last
page of the Control Panel User Guide with the random
code number, in order to obtain a 4-digit Anti-Code.
!
The area that the alarm occurred in cannot be
armed again until the alarm has been reset.
Enter the Anti-code that has been given, i.e. 5624, the
display will look something like this:
^%").#X#8723
Q.N@$#X#:478
Press
#
##
#
, the display should look like this:
0+.--#Q IAIM#) "
B@.'+#) C.#*@' +,
Press
(
((
(
to clear the alarm.
The external strobe will stop, the system will chime and the
display will return to normal.