e
rm
ng
enu
rem
er
ser
anua
10 INS177
To Silent Arm the System
➤ To silent arm the system, proceed as follows:
Ensure that the premises are secure (all doors and
windows closed etc.) and the Ready light is on.
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
)
))
)
until the display looks like this:
!"#$"%#&'()#)"
A1@.()#*+,/
Press
#
##
#
to arm the system
Or
Press
'
''
'
to part arm the system.
Continue to arm as normal.
To Cancel the Exit Mode
➤ To cancel the exit mode, proceed as follows:
The display will look something like this:
*+.'-#1 (#IJ1) #X
####*U9 99999#
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%# &'()#) "
B'(>.@# IJ1)/
Press
#
##
#
, the exit tone will stop and the display will look
something like this:
###0+.,1.+#222
#M%.#54#K'+#7553
The exit mode has now been cancelled.
To Disarm the System During Entry
➤ To disarm the system, proceed as follows:
Enter the premises via the designated entry point, the
entry tone will start and the display will look something like
this:
*+.'-#1 (#I()+ $#X
####*UB 99999#
Enter a valid User code
....
........
....
, the entry
tone will stop and the display will look something like this:
##0+.,1 .+#234 2
3868495 8N#M%. #54
The system is now disarmed.
!
If the entry time expires, an Internal alarm will occur
for the duration of the ‘2
nd
Entry Delay’.
If the 2
nd
Entry Delay expires, an Intruder alarm will
occur (all internal and external sounders).
To Disarm the System When Not in Entry
➤ To disarm the system, proceed as follows:
The display will look something like this:
##0+.,1 .+#234 2
3868495 8N#M%. #54
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
!1-'+,#A$-).,/
Press
#
##
#
, the display will look something like this:
###0+.,1.+#222
#M%.#54#K'+#7553
The system is now disarmed.