Texecom Premier 888 - Keypads; Display Window; Keys

P
rem
i
er
888
an
d
8168
I
ns
t
a
ll
a
ti
on
M
anua
l
C
on
t
en
t
s
INS177 5
Keypads
One or more keypads will be installed throughout the
protected premises, usually one at each entry/exit door.
The keypads are used to perform all of the system
functions i.e. Arming, Disarming etc.
Display Window
Premier LCD & LCDL Display
The 32-Character LCD display is used to show the status
of the system and to view system data.
Power LED
The Power LED will illuminate when AC Mains is
connected to the control panel and will flash when the
system is running on the standby battery.
Info. LED
The Info. LED can be programmed to mimic the keypad
output or show the armed status of an area.
Ready LED
The Ready LED will illuminate when all zones assigned to
the same area as the keypad are secure and the system is
ready for arming.
Omit LED
The Omit LED will illuminate whenever zones assigned to
the same area as the keypad have been omitted.
Service LED
The Service LED will illuminate whenever the system has a
fault and requires attention i.e. Tamper fault, reset
required, service required etc.
Normal and Function Keys
Keys
!
!!
!
to
"
""
"
These keys are for entering User codes or inputting data
when in programming mode.
Yes & No Keys
#
##
#
&
$
$$
$
The YES key is used to accept actions and the NO key is
to cancel actions.
Omit Key
%
%%
%
This key is used to omit zones (see page 15 for details).
Chime Key
&
&&
&
This key is used for turning the zone chime feature on and
off (see page 16 for details).
Part Key
'
''
'
This key is used to part arm the system (see page 7 for
details). It can also be used to do a ‘Quick’ part arm if this
feature is enabled.
Area Key
%
%%
%
This key is used to arm or disarm particular areas (see
page 11 for details). It can also be used to do a ‘Quick’
area if arm feature is enabled.
Reset Key
(
((
(
This key is used to exit from the Arming or User menu, to
reset the system and also to display the Reset, Anti-code
and Service messages (see page 7 for details).
Scroll Key
)
))
)
This key is used to scroll through the various menus and
options.
Menu Key
%
%%
%
This key is used to select the Arming or User menu.
Emergency Keys
In case of emergency, the alarm system can provide three
immediate emergency alarms by pressing and holding two
specific keys for three seconds.
Emergency Alarm Press Keys
Panic
!
&
*
Fire
+
&
,
Medical
-
&
"
!
The emergency keys can be enabled/disabled for
each keypad on the system.
The Panic alarm can be individually programmed for
either audible or silent operation for each keypad.
The Panic alarm can be individually programmed for
either instant or delayed operation for each keypad.
Premier LCD
Display
Programmable
‘Info.’ LED
4
7
Area
1
Ye s
Part
Chime
Omit
Reset
Menu
Pow er
In fo.
Read
y
ServiceOm it
Function
Keys
Premier LCDL
Large Display
Screen N ot Show n
Normal
Keys
23
5
8
0
6
9
No