Texecom Premier 888 - Enable Engineer; Set System Time

Th
e
U
ser
M
enu
P
rem
i
er
888
&
8168
U
ser
M
anua
l
26 INS177
Enable Engineer
If Engineer access (either on-site or via remote download
computer) has been programmed as User authorised, this
option must be used to allow the Engineer access to the
programming menu. Users with access to this option can
authorise Engineer access.
!
Engineer access is only permitted for 4 Hours after it
is enabled, after which, it will automatically be
disabled again.
➤ To enable Engineer access, proceed as follows:
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
/
//
/
, the display should look like this:
!"#$"%#&'()
G-.+#K.(%/
Press
#
##
#
, the display should look like this:
!"#$" %#&'()# )"
=1.&# A$-).,# T"L/
Press
)
))
)
until the display looks like this:
!"#$" %#&'()# )"
I('P@ .#I(L1( ..+/
Press
#
##
#
, the display will look something like this:
I(L1(.. +#*>>. --X
!1-'P@. <
Press
$
$$
$
to enable/disable Engineer access, the
display will look something like this:
I(L1(.. +#*>>. --X
I('P@.<
Press
#
##
#
, the display should look like this:
!"#$" %#&'()# )"
I('P@ .#I(L1( ..+/
Press
(
((
(
to exit the menu and return to normal.
Set System Time
The alarm system has a real time clock that is used to date
and time stamp events that are recorded within the system
Log. Users with access to this option will be able to set the
Time on your alarm system.
➤ To set the system time, proceed as follows:
Enter a valid User code
....
........
....
, the display
should look like this:
!"#$"%#&'()#)"
*+,#-$-).,/
Press
/
//
/
, the display should look like this:
!"#$"%#&'()
G-.+#K.(%/
Press
#
##
#
, the display should look like this:
!"#$" %#&'()# )"
=1.&# A$-).,# T"L/
Press
)
))
)
until the display looks like this:
!"#$" %#&'()# )"
A.)#A $-).,#M 1,./
Press
#
##
#
, the display will look something like this:
I().+#_ .&#M1, .#X
#####37 672#UA M
Enter the new time (24-Hour format)
5566
55665566
5566
, the display will look something like
this:
I().+#_ .&#M1, .#X
#####73 68:#UA M
Press
(
((
(
to change between BST and GMT, the display
will look something like this:
I().+#_ .&#M1, .#X
#####73 68:#dK M
Press
#
##
#
, the display should look like this:
!"#$" %#&'()# )"
A.)#A $-).,#M 1,./
Press
(
((
(
to exit the menu and return to normal.