Premier Elite 8XP-W & 32XP-W Installation Manual
10 INS467-4
5: Lid Tamper
When open puts the system into commission mode and digitally attenuates the receiver signal by
15Db.
6: Programming LED’s
Allows programming of devices directly to the receiver, in conjunction with the learn switch.
7: Antenna
RF Antenna.
Premier 32XP-W = 2 x Antenna
Premier 8XP-W = 1 x Antenna
8: Network LED's
Green LED = Data received by the expander from the panel Red LED = Data transmitted by the
expander to the panel. (The flash rate depends on the mode and RF activity)
9: Heartbeat LED
Flashes steadily to indicate that the receiver is functioning correctly. If the light is ON or OFF all the
time, then there could be a hardware problem.
10: Learn Switch
To be used with programming LED’s to learn devices directly to the receiver.
11: Options Switch
Use to select the receiver functionality depending on panel firmware.
Switch 1 ON =firmware dependant, please see the relevant programming section.
Switch 2 ON = Legacy Mode
OFF = RICOCHET™
Switch 3 ON = Impaq Contact-W Wired Input 2 will report as Tamper (default)
OFF = input 2 will report as an Alarm.
Switch 4 Walk test
12: Address Switch
Used to assign the address of the receiver on the premier network
13: RF LED
Flashes when transmitting or receiving RF data
14: Tamper Disable
Disables the lid and rear tamper
15: Engineer’s Keypad LED's
Red LED flashes constantly, the flash rate increases when data is being transmitted.
16: Flash Programming Port
Variant dependent, for flashing the expander with updated firmware.
To Next Page
Loading...
