Texecom Premier Elite 8XP-W - Device Status Indications (V1 only); Top Line Device Status Codes; Bottom Line Device Status Messages

Premier Elite 8XP-W & 32XP-W Installation Manual
INS467-4 39
Device Status Indications (V1 only)
On the top line of the display the following may be seen depending on the device and status:-
 = all devices Front Tamper
 = all devices Rear Tamper
 = Pir is Active
 = Impaq Mag & Impaq Plus Reed Switch Open
 = Impaq Mag Input 1 Active
 = Impaq Mag Input 2 Active
 = Impaq Plus Shock Sensor Active
On the bottom line of the keypad when circumstances dictate the following messages may be seen:-
  = Low Battery
  = Receiver has just powered up and has not
heard from the device
  = Device Fault
 
= Shows when Device Attributes have been
updated on the receiver but the device has not polled in
or been updated by the Update Devices menu. This
display also shows which devices are still out of date if
the Update Devices broadcast message fails.
 = Device has not polled
in and has been
lost on the system.
    
 
    
 
    
 
    
 
    
 
    
 
    
 
    
  
    
  
    
 
    
  
    
 