Texecom Premier Elite 8XP-W - Direct Learning to Expander; Legacy Mode Learning; Initiating Learn Sequence; Device Slot Indication

Premier Elite 8XP-W & 32XP-W Installation Manual
INS467-4 31
Learning Devices directly to the 8XP-W & 32XP-W
 this is only available in legacy mode.
All devices can be learnt directly to the receiver. Device attributes cannot be changed when learning
devices in this mode, all devices will use their factory default.
To initiate the learn sequence press the Learn Switch on the receiver see page 9. The right hand
LED 1 will illuminate, keep pressing the learn switch until the correct LED sequence is seen for the
device that you want to add to the system.
Free device slots are indicated by the corresponding LED’s flashing, if the LED’s do not flash then
that slot is already occupied by another device. Depress the Learn switch on the device and insert
the battery. Repeat this sequence for subsequent devices.
Once complete devices should be learned to the control panel using the relevant instructions for
your control panel and firmware; 24/48/88/168 & 640 see page 21, 412/816 & 832 see page 27
L eft H and LE D’s R ight H and LE D ’s L eft H and LE D’s
R ight H and LE D ’s
1
2 3
4 1
2 3 4 1 2
3 4
1 2 3 4
Not Learning
Learning device 20
Learning device 1
Learning device 21
Le a rn in g de vi c e 2 Learning device 22
Le a rn ing de vic e 3
Le a rn ing de vic e 23
Le a rn in g de vi c e 4
Learning device 24
Le a rn in g de vi c e 5
Learning device 25
Le a rn ing de vic e 6
Le a rn ing de vic e 26
Le a rn in g de vi c e 7 Learning device 27
Le a rn in g de vi c e 8 Learning device 28
Le a rn in g de vi c e 9
Learning device 29
1 2 3
4 1 2 3 4
1 2 3 4 1
2 3 4
Learning device 10
Le a rn ing de vic e 30
Le a rn ing de vic e 11
Le a rn ing de vic e 31
Le a rn ing de vic e 12
Le a rn ing de vic e 32
Le a rn ing de vic e 13
Le a rn ing de vic e 14
Le a rn ing de vic e 15
Le a rn ing de vic e 16
Le a rn ing de vic e 17
Learning devic e 18
Le a rn ing de vic e 19