Texecom Premier Elite 8XP-W - Walktest Mode; Initiating and Stopping Walktest; Walktest Mode Benefits; Walktest Broadcast Failure

Premier Elite 8XP-W & 32XP-W Installation Manual
INS467-4 37
Walktest Mode
Used to initiate & stop Walktest Mode
 
 
 
   
 
   
When u pd atin g devic es a mes s ag e is
sen t to all to ena bl e th e LE D’ s & re du ce
the co mmu nication ti me to 10 se c’s
b etwee n ac tiva ti on s . P ol lin g time i s n ot
affected .
 
  
 
   

/


/


/

If the Walktest broadcast message fails the following will be seen
 
 
 
   

/

 
   
 
   

/


/

In this case the system has not had time to synchronise properly, if you are in Commission Mode
page 44 you should wait 4 minutes and try again. If not in commission mode you should wait 15
minutes and try again.