Premier Elite 8XP-W & 32XP-W Installation Manual
INS467-4 15
Device Modes of Operation
Always Awake
This mode should only be used on devices which are required to signal at all times and is the default
setting for the Impaq Contact-W and Impaq Plus-W.
Auto Mode
When in Auto Mode, devices poll at 15 minute intervals. Following activation, devices will not
transmit the same activation again for a period of 3 minutes.
Hybrid Mode
Hybrid mode is used to control the reporting functions for devices. When in the mode devices are
asleep when the system is set, and are woken up by the control panel at the point of arming. When
the system is disarmed the devices will be put back to sleep. This mode of operation is the default
mode for XT-W, QD-W & DT-W.
On very large systems (100 devices +) a small delay may be experienced when arming the system, this is normal
as the expanders on the system wake up the relevant devices.
Premier Elite DT-W should ALWAYS be used in Hybrid mode, failure to do this will have an adverse affect on
battery life.
Expander O/P Mode
Expander O/P modes are for future use and should not be used with any of the devices listed above.
Zone Types & Attributes
These are all the same as before and detailed instructions for programming can be found in INS176-
8 or later.
To Learn Devices please follow the diagram on the next page
To Next Page
Loading...
