Texecom Premier Elite 8XP-W - Premier Elite SmartKey; SmartKey Learning and Functionality; SmartKey Routeing; Route By Function

Premier Elite 8XP-W & 32XP-W Installation Manual
INS467-4 17
Premier Elite SmartKey™
Introduction
Premier Elite SmartKey™ are now learnt and all functionality managed through the “Setup Users”
Menu.
Ricochet™ MT2 and Premier Elite Series V2 firmware upgrades add additional capabilities to the
management of Premier Elite SmartKey™. In multiple expander systems it is now possible to
choose which zones (and therefore expander) the Premier Elite SmartKey™ will use for its routeing,
LED and Aux functions can also be changed within the “Setup Users” menu.
All users on the system can have a Premier Elite SmartKey™ a TAG and a code, or any
combination of them.
This section only deals with Premier Elite SmartKey™ learning and routeing, all other user
programmable options can be found in INS176-8 Premier Elite Series Installation Manual or later.
 Great care should be taken when using large numbers of Premier Elite SmartKey™, only one Premier Elite
SmartKey™ per expander can be used by the system at any one time, and on Multiple expanders systems, or
large sites, functionality should be checked in all areas of the site where the device may be used.
Premier Elite SmartKey™ Routeing
Premier Elite SmartKey™ should only be learned to the system AFTER all devices have been
learned and placed in their final location. Whilst it is possible to learn at any point during the
programming of the system, learning and testing the functionality of the Premier Elite SmartKey™
after all devices have been placed will ensure that the Premier Elite SmartKey™ performs as
expected, and works in locations where the user would expect it too.
Route By
The Route By function allows you to select which Zones (and therefore expander) the Premier Elite
SmartKey™ will use on the system for its routeing. This should be selected BEFORE the device has
been learned.
In the examples below Fig 1 shows the zones associated with Expander 1, which is a 32XP-W, and
Fig 2 shows Expander 2 which is also a 32XP-W, when using 8XP-W there willobviously be less
devices that the Premier Elite SmartKey™ can use.
  
   
Fig 1
  
   
Fig 2
The  key is used to select this menu and the  key used to select which expander and
associated zones will be used
Once a Premier Elite SmartKey™ has been learned the  key will show which zones are being
used for routeing. It is not possible to alter this once learned. To change the routeing the Premier
Elite SmartKey™ should be deleted and the process started from the beginning.