Texecom Premier Elite 8XP-W - Removing SmartKey; SmartKey Unassignment Flowchart

Premier Elite 8XP-W & 32XP-W Installation Manual
26 INS467-4
SmartKey™
If a SmartKey™ is no longer required it must be unassigned from the system. To remove a
SmartKey™ from a user, proceed as follows:
1. Select engineer’s mode by entering the engineer code followed by / then .
2. Enter  to select the Program Users menu.
3. Enter the two digit user number that you want to remove the SmartKey™ from e.g., .
4. Press the / key, the panel will generate an acceptance tone and the SmartKey™ is no
longer assigned to the selected user. Note: If the SmartKey™ was assigned to user 02
onwards the user access code is also deleted.
 
   
  
  

Enter User
Number

  
  
Enter Engineers code
Then press then
/

 
Acceptance Tone
from Panel

/
