Premier Elite 8XP-W & 32XP-W Installation Manual
6 INS467-4
3. Ricochet MT2
The Premier Elite Series™ of control panels have been upgraded to V2.xx firmware which now
contains Ricochet™ MT2 capability. This new technology adds additional features and functions
for Ricochet™ enabled security systems. The Expanders used must be Premier Elite XP-W V2.xx.
DO NOT mix V1 & MT2 expanders on the same Premier Elite panel
Multiple Expander Support
It is now possible to add multiple expanders to the system allowing for greater flexibility in system
design, and also taking wireless capability to new levels. Additional device modes and diagnostics
functions also give more information about the system status, and allow greater control over
devices modes of operation.
Control Panel Capacity
The table below details the maximum number of expanders, devices and Premier Elite
SmartKey™ that may be used on the different control panels, other configurations may be
possible by mixing Premier Elite 32XP-W & Premier Elite 8XP-W.
Panel
32XP-W 8XP-W
Expanders Devices
Premier Elite
SmartKey™
Expanders Devices
Premier Elite
SmartKey™
Premier Elite
24™
1 16 16 2 16 25
Premier Elite
48™
1 32 16 4 32 50
Premier Elite 48-
W™
N/A 32 16 N/A N/A N/A
Premier Elite
88™
2 64 32 8 64 100
168™
4 128 64 16 128 200
Premier Elite
640™
16 512 256 16 128 256
Premier Elite 32XP-W take 4 address slots on the network, Premier Elite 8XP-W take one address
System Requirements
To enable all of the advanced functionality and diagnostics capability Ricochet™ MT2 the
following are minimum requirements:-
• Wintex™ Version 6 Build 16 or later
• Ricochet Monitor™ 0.2.15.00 or later
• Premier Elite™ Series V2.xx or later
• Premier Elite™ 32XP-W & 8-W Expanders V2.xx or later
To Next Page
Loading...
