Texecom Premier Elite 8XP-W - Ricochet MT2 Diagnostics Continued; Signal Security Display; Device Status Codes

Premier Elite 8XP-W & 32XP-W Installation Manual
INS467-4 41
  
   
This display shows that no message has been received yet, this would
normally be seen on a
recently powered up system, wait 15 minutes from power up before checking the diagnostics
information.
Signal Security™
  

This display shows information relating to signal security on an 8XP-W. 4 windows are
available to show information; each window represents two devices, (Odd & Even device
slots). Each window could show any of the information detailed in the table below
? No information is available
_ The chosen device cannot “see” either of the
devices
O The chosen device can see the ODD device(s)
E The chosen device can see the EVEN device(s)
B The chosen device can see BOTH devices
Example
  

In this example Zone 9 can see the devices as detailed below, use
the scroll
key to view information about other devices:-
Display    
Device 1 2 3 4 5 6 7 8
Can see        
 On the 32XP-W there are 16 windows to show information from the 32 devices of the system; the format is the
same.
Device Status
  
 
Secure/OK Active/Fault Type
a A Mag1
a A Mag2/Sho
a A Reed/PIR
s
S
Poll/Supervision
p P Power/Battery
d D Device
t T Rear
t T Front