A40i, A60i
Manual 0-5466 INTRODUCTION
2-1
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Owner’s Manual applies to just specification or part numbers listed on page i.
To ensure safe operation, read the entire manual, including the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION, and NOTE may appear. Pay particular attention to the
information provided under these headings. These special annotations are easily recognized as follows:
NOTE!
An operation, procedure, or back-
ground information which requires
additional emphasis or is helpful in
ecient operation of the system.
CAUTION
A procedure which, if not properly
followed, may cause damage to the
equipment.
!
WARNING
A procedure which, if not properly fol-
lowed, may cause injury to the opera-
tor or others in the operating area.
WARNING
Gives information regarding possible
electrical shock injury. Warnings will
be enclosed in a box such as this.
Additional copies of this manual may be purchased by contacting Thermal Dynamics at the address and phone
number in your area listed on back cover of this manual. Include the Operating Manual number and equipment
identification numbers.
Electronic copies of this manual can also be downloaded at no charge in Acrobat PDF format by going to the ESAB
web site listed below and clicking on "Product Support" / "ESAB Documentation": / "Download Library", then
navigate to "Plasma Equipment" and then "Manual".
http://www.esab.com
2.02 Equipment Identification
The unit’s identification number (specification or part number), model, and serial number usually appear on a data
tag attached to the bottom. Equipment which does not have a data tag such as torch and cable assemblies are iden-
tified only by the specification or part number printed on loosely attached card or the shipping container. Record
these numbers on the bottom of page i for future reference.
To Next Page
Loading...
Need help?
General
