A40i, A60i
Manual 0-5466 INSTALLATION
3-3
3.06 Primary Input Power Connections, THREE Phase
WARNING
Each A40i or A60i system is a dedicated 1 Phase OR 3 Phase
system and cannot be recongured to the other. Personal injury
could occur if changing the phase is attempted..
CAUTION
The primary power source, fuse, and any extension cords used
must conform to local electrical code and the recommended
circuit protection and wiring requirements as specied in Sec-
tion 2.
Line
GND
Three-Phase (3ø)
Power
Cord
Power Switch
Three Phase Input Power Wiring
NOTE!
As long as the power supply is connected to input power
ranging from 208 VAC to 480 VAC, the system will automati-
cally detect this and run accordingly.
To Next Page
Loading...
Need help?
General
