Thermal Dynamics A40i User Manual

Plasma Cutting Power Supplies
A40i, A60i
SL100SV 1Torch™
Operating Manual Number 0-5466
Published by:
Thermal Dynamics
2800 Airport Rd.
Denton, Texas 76207
www.Thermal-Dynamics.com
© Copyright 2017 by
Thermal Dynamics .
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is
prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or
damage caused by any error or omission in this Manual, whether such error results from negli-
gence, accident, or any other cause.
For Material Print Specifications, refer to document 47x1909
Original Publication Date: 16 November, 2017
Revision Date: 7/3/18
Record the following information for Warranty purposes:
Where Purchased:_______________________________ __________________
Purchase Date:__________________________________ __________________
Power Supply Serial #:___________________________ ___________________
Torch Serial #:___________________________________ _________________
i
!
WARNING
Read and understand this entire Manual and your employer’s safety practices
before installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer’s
best judgement, the Manufacturer assumes no liability for its use.

Thermal Dynamics A40i Specifications

General

Brand	Thermal Dynamics
Model	A40i
Category	Cutter
Language	English