Thermal Dynamics CUTMASTER - System Service and Maintenance; General Maintenance Schedule

CUTMASTER 35mm, 40mm
Manual 0-5118 5-1 SERVICE
SECTION 5 SYSTEM:
SERVICE
5.01 General Maintenance
Warning!
Disconnect input power before maintaining.
Each Use
Visual check of
torch tip and electrode
Weekly
Visually inspect the torch body tip,
electrode, start cartridge and shield cup
Visually inspect the
cables and leads.
Replace as needed
3 Months
Clean
exterior
of power supply
6 Months
Replace all
broken parts
Visually check and
Carefully clean the
interior
Maintain more often
if used under severe
conditions
Art # A-07938_AB