WARNING
WARNING
Read and understand this entire Instruction Manual and your
employer’s safety practices before installing, operating, or
servicing the equipment.
While the information contained in this Instruction Manual
represents our best judgement, Thermal Dynamics Corporation
assumes no liability for its use.
Pak Master
®
50 Air Plasma Cutting Power Supply
Instruction Manual Number 0-2470
Published by:
Thermal Dynamics Corporation
Industrial Park No. 2
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
Copyright 1995 by
Thermal Dynamics Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written
permission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability
to any party for any loss or damage caused by any error or
omission in the Pak Master
®
50 Air Plasma Cutting Power Supply
Instruction Manual, whether such error results from negligence,
accident, or any other cause.
Printed in the United States of America
October 20, 1997
To Next Page
Loading...
