GENERAL IDESCRIPTION 12 Manual 0-2470
• Remote Control (RC) Wire Harness ......................Cat. No. 9-6210
For converting a hand cutting system to mechanized use with a
remote hand pendant control or computer control (CNC) cable.
• Remote Hand Pendant Control..............................Cat. No. 7-3114
Hand-held remote ON/OFF control device for systems with
remote wire harness installed. Includes a 25 ft (7.6 m) cable.
• Computer (CNC) Interface Cable - 25 ft (7.6 m) ..Cat. No. 8-5557
Computer (CNC) Interface Cable - 50 ft (15.2 m) Cat. No. 8-5558
For interfacing the power supply with a computer or auxiliary
control device. Provides ON/OFF, OK-to-move, and corner
slowdown signals. (Remote wire harness must be installed.)
• High Pressure Regulator - Air................................Cat. No. 9-3022
High Pressure Regulator - Nitrogen (N
2) .............Cat. No. 9-2722
• Running Gear............................................................Cat. No. 7-3201
For transporting the system with torch and leads storage.
• Air Line Filter - Single Stage ...................................Cat. No. 7-3265
Air Line Filter - Two Stage......................................Cat. No. 7-3340
Remove damaging moisture and contaminants from the air
stream when using compressed air.
• 575V Transformer Unit............................................Cat. No. 9-6211
For operating standard systems with 575V three-phase input.
• Spare Parts Kit - MaximumLife™.......................... Cat. No. 5-6001
Spare Parts Kit - Gouging .......................................Cat. No. 5-6015
Kits contain replacement front-end torch parts (see detailed
description of spare parts kit contents on page 80).
• Leads Extension Kit - PCH-35, 25 ft (7.6 m) .........Cat. No. 4-6007
Leads Extension Kit - PCH-35, 50 ft (15.2 m) .......Cat. No. 4-6008
Leads Extension Kit - PCM-35, 25 ft (7.6 m) .........Cat. No. 4-6009
Leads Extension Kit - PCM-35, 50 ft (15.2 m) .......Cat. No. 4-6010
For extending torch leads up to 150 ft (45.7 m).
• Phenolic Mounting Tube.........................................Cat. No. 7-3251
Phenolic Pinch Block Mounting Assembly ..........Cat. No. 7-3252
For machine mounted torch applications where a non-metal
mounting assembly is desired.
• Switch Lever Kit .......................................................Cat. No. 8-5170
Provides a lever for activating the hand torch control switch.
See System Components and Accessories (page 70) or Torch
Options and Accessories (page 80) for more information.
2.03 OPTIONS AND ACCESSORIES
Pak Master 50
System Options and
Accessories
Torch Options
and Accessories
NOTE
To Next Page
Loading...
