36
TK 56704-1-OP-EN
IImmppoorrttaanntt:: If the setpoint is changed using the + or - keys, the change must
be confirmed or rejected by pressing the YES or NO soft key
within 10 seconds of changing the setpoint.
• If the YES key is pressed, the setpoint change made with the + or - key is
accepted, the setpoint changes, and the display returns to the Standard
Display.
• If the NO key is pressed, the setpoint change made with the + or - key is
not accepted, the setpoint is not changed, and the display returns to the
Standard Display.
• If either the YES or NO key is not pressed within 10 seconds of making a
change with the + or - key, the setpoint is not changed, and the display
returns to the Setpoint Display. The display briefly shows [SETPOINT
NOT CHANGED] and Alarm Code 127 Setpoint Not Entered is set, to
indicate that a setpoint change was started but not completed.
Figure 32. Standard Display, New Setpoint
Starting the Diesel Engine
CCAAUUTTIIOONN
RRiisskk ooff IInnjjuurryy!!
The engine may start automatically any time the unit is turned on.
NNOOTTIICCEE
EEqquuiippmmeenntt DDaammaaggee!!
Never use starting fluid. Damage to the engine can occur.
Diesel engine preheats and starts are automatic in both Continuous Mode
and CYCLE-SENTRY Mode. The engine will preheat and start as required
when the unit is turned on. The engine preheat and start will be delayed in
CYCLE-SENTRY mode if there is no current need for the engine to run. If any
OOppeerraattiinngg IInnssttrruuccttiioonnss ffoorr PPrreemmiiuumm HHMMII CCoonnttrrooll PPaanneell
To Next Page
Loading...
Need help?
General
