38
TK 56704-1-OP-EN
Electric motor starting is automatic in both Continuous Mode and CYCLE-
SENTRY Mode. The motor will start as required when the unit is turned on. If
any keys are being pressed on the HMI Control Panel prior to the motor start,
the motor start will be delayed until 10 seconds after the last key is pressed.
When the motor is preparing to start, the HMI Control Panel will display the
motor start screen (Figure 34, p. 38). The preheat buzzer sounds for 20
seconds before the electric motor starts.
Figure 34. Motor Start Screen
After the motor is running, the display returns to the Standard Display of
temperature and setpoint.
Switching from Diesel to Electric
NNoottee:: Units equipped with the Electric Standby option only.
If the Diesel to Electric Autoswitch Enabled feature in Guarded Access is set
YES, the unit will automatically switch to Electric Mode operation when
standby power is connected and available.
If the Diesel to Electric Autoswitch Enabled feature in Guarded Access is set
NO, the prompt screen shown (Figure 35, p. 39) will appear when standby
power is connected and available.
OOppeerraattiinngg IInnssttrruuccttiioonnss ffoorr PPrreemmiiuumm HHMMII CCoonnttrrooll PPaanneell