TK 56430-18-IP-EN
37
into the drain plug of the compressor. Be careful not spill.
Figure 21. Add oil to compressor.
6. Replace the drain plug bolt and torque to 9 ft﹒lbs.
7. Place a small amount of compressor oil onto each green O-ring around the compressor ports and coat the entire
mating surface.
Figure 22. Add oil to O-rings.
8. Place the swivel manifolds on the compressor ports and place the manifold retainer over the manifolds.
9. Add blue thread locker to the end of the manifold retainer bolt as shown below. Add enough to coat one thread one
revolution around the bolt.
Figure 23. Add blue thread locker to retainer bolts.
10. Place the bolt through the manifold retainer and torque to 36.9 ft﹒lbs. (50 N﹒m).
IImmppoorrttaanntt:: Do not use an impact drive to tighten this as it may damage the manifold and/or compressor.
NNoottee:: Before torquing the retainer bolt, a test fit may need to be performed onto the drive kit to verify the manifolds
are in the correct orientation to connect with the refrigerant lines.
11. Rotate the compressor clutch by hand several times to verify the oil spreads to lubricate the internal components.
SSeeccttiioonn 55 -- CCoommpprreessssoorr SSeelleeccttiioonn aanndd IInnssttaallllaattiioonn SSttaannddaarrddss
To Next Page
Loading...
