TK 56430-18-IP-EN
41
Figure 30. Angular Misalignment
Changing Compressor Clutch
Removal
If the compressor is installed on the vehicle, verify that there is enough room in the engine compartment to work
without damaging the compressor or any adjacent components. If there is not, remove the compressor from the
engine. Place a suitable holding tool between the armature’s rubber dampers to prevent rotation (Figure 31, p. 41). Use
a 10 mm socket and wrench to remove the armature retaining bolt.
Figure 31. Removing Armature Retaining Bolt.
1. Armature Retaining Bolt
Remove the armature assembly from the compressor shaft and the snap ring holding the pulley onto the compressor
shaft (Figure 32, p. 42). If using a new clutch assembly, discard the snap ring and use the new one supplied with the
clutch kit.
NNoottee:: There may be shims installed between the armature assembly and the compressor shaft. Set these shims aside
as they will be reused during installation.
SSeeccttiioonn 55 -- CCoommpprreessssoorr SSeelleeccttiioonn aanndd IInnssttaallllaattiioonn SSttaannddaarrddss
To Next Page
Loading...
