Thermo Scientific Smart-Vue - Page 40

Preventive Maintenance Guidelines
36
Smart-Vue Administrator Manual Thermo Fisher Scientific

Figure 16. Smart-Vue end-point module interface overview
2.1.4.2 Alarm conditions shown
on LCD
When alarms are configured in Smart-Vue Client, the LCD on the
Smart-Vue end-point module changes if an alarm condition is detected.
Battery level
–10%
–40%
–70%
Sensor name or
serial number
(also displays
status message
for alarms)
Wireless signal
strength
– 0%
– 30%
– 50%
– 70%
– 100%
Latest sensor reading
Multi-function
push-button
Single press to update
reading on single
module.
On double module,
press again to read
second sensor.
Long-press-3 secs this
can be done any time,
but is recommended
to use for installation
only to initiate
discovery process.