Thinkware X800 - Using recording features; Turning the product on or off

21
3.󳒀 Using recording features
3.1󳒀 Turning the product on or off
The product is turned on automatically and continuous recording starts when you turn on the ACC or start
the engine.
•󳒀 Wait until the product is completely booted up after turning it on, and then begin operating the vehicle. The
video recording does not begin until the product is completely turned on (booted up).
•󳒀 If you want to turn off the product, slide up the Power switch. To turn the power on again, slide down the
Power switch.
3.2󳒀 Turning the LCD on or off
This product allows you to check recorded videos in real time on the LCD display by supporting the live
view feature.
You can set the time that the LCD will turn off automatically. Tap the Home menu ( ) button on the Live
view screen
>
Settings
>
System Settings, and select the desired time from LCD Auto-Off.
LCD Auto-Off option Operation description
30 sec. (default) The LCD will turn off automatically if you do not operate the product for 30 seconds.
1 min. The LCD will turn off automatically if you do not operate the product for 1 minute.
10 min. The LCD will turn off automatically if you do not operate the product for 10 minutes.
OFF The LCD is always on.
3.3󳒀 Learning about LED indicators and file storage locations
LED indicators
You can check the operating status, even when the LCD is turned off, by checking the LED indicators on the
rear of the product.
For more information about what the LED indicates in each recording mode, refer to the corresponding
section of the recording mode (the continuous recording, the manual recording, and parking mode recording).