3. Wiring
1.
How to wire
3-10
TSC
1-2-4
Connect to driver controller TSC
1
.
Check that the power of TSC is not turned ON.
2.
Connect the motor connector (black)
to the CN4 of TSC.
If it is connected properly, it should be
locked and cannot be fallen off even by
pulling it lightly.
* Do not pull it strongly.
3.
Connect the encoder connector
(white) to the CN2 of TSC.
If it is connected properly, it should be
locked and cannot be fallen off even by
pulling it lightly.
* Do not pull it strongly.
To Next Page
Loading...