5. Press the [+] button to turn the pattern function on.
ð
The value changes to ‘Pattern: ON’. The pattern function is enabled for the selected
pad.
6. Press the [SAVE/ENTER] button.
ð
The display now shows the parameter ‘Grp:’. Use the [+] / [–] buttons or the jog
wheel to select the desired pattern or song group.
7. Press the[PAGE+] button.
ð
The display now shows the parameter ‘Sng:’. Use the [+] / [–] or the jog wheel to
select the desired pattern or song.
8. To select and modify the other parameter (see table below) use the [PAGE+] button. Use
the [+] / [–] buttons or the jog wheel to change the parameter value. The number of the
set value appears in the lower right corner of the display in the ‘DATA’ field.
9. Press the [SAVE/ENTER] button.
ð
The display shows ‘Sv> MyKit001’. Use the [+] / [–] buttons or the jog wheel to select
the user kit that you want to save the settings with.
10. Press the [SAVE/ENTER] button.
ð
Now you can rename the kit or save it with its original name using the [SAVE/ENTER]
button. ‘SAVE OK!’ will confirm the storing.
Operation
e-drum module
32
To Next Page
Loading...
Need help?
General