With your drum set, you can use the existing preset kits as a basis for user kits. The user kits can
then be either stored in the device or on an SD card.
1. Use the [PAGE –] button to change to the preset kit group and select the desired kit with
the [+] / [–] buttons or the jog wheel.
2. Press the [SAVE/ENTER] button.
ð
The display shows ‘Sv>’ as well as the number and name of the first user kit, in fac‐
tory default condition ‘MyKit001’. The current memory slot is indicated in the lower
right area of the display as ‘DATA xxx’.
3. Use the [+] / [–] buttons or the jog wheel to select that user kit, you want to assign set‐
tings of a preset kit to.
4. Press the [SAVE/ENTER] button.
ð
The first character of the kit name is highlighted and can be changed using the [+] /
[–] buttons or the jog wheel. Use the [PAGE –] and [Page +] button to move the
cursor to the next or previous position.
5. Confirm the change with [SAVE/ENTER].
ð
The display briefly shows ‘SAVE OK!’. Then the original kit is displayed with the new
name and the new memory slot. The change of the presets take effect immediately.
Modifying and saving user kits
Operation
MPS-600
37
To Next Page
Loading...
Need help?
General