If multiple sounds are generated in a row when playing a pad, this is called ‘double trigger‘.
This effect can e.g. be caused by irregular waveforms, especially in trigger decay. With
"Retrig_C", these distortions can be suppressed. The higher this value is set, the more likely it is,
that hits in rapid succession - for example in a drum roll - are no longer detected. The value
should therefore be set as low as possible.
When several pads are mounted on the same rack, vibrations may be transferred to other pads
and thus, unwanted sounds are triggered when hitting a pad. This crosstalk can be prevented
by a corresponding setting of the 'X-Talk' parameter. The value should be set as low as pos‐
sible.
The slew rate of the trigger waveform varies due to construction type. That means, that the
volume may vary even given a uniform touch intensity. This effect can be suppressed with
"Scan-T". The higher the value is set, the more precise the velocity is analysed. The value
should be set as low as possible because it affects the release time of the trigger.
This parameter affects the suppression time, i.e. the response time of the trigger after playing
it.
Retrig_C
X-Talk
Scan-T
Rjct-T
Operation
MPS-600
67
To Next Page
Loading...
Need help?
General