Thomas T105 - Page 59

59
5...SPECIFICATIONS
Controls
VEHICLE: Steering direction and speed controlled
by two hand operated control levers.
HYDRAULICS: Lift, bucket tilt and auxiliary hydraulic
functions controlled by separate foot
pedals.
ENGINE: Hand lever throttle, engine stop and key
type ignition switch.
Engine
Make and model ................................Kubota V1505-E3B
Cylinders...........................................................................4
Cooling system ........................................................Liquid
Displacement ................................91.41 cu. in. (1498 cc)
Horsepower (kW) Gross ..........35.5 (26.5) @ 3000 RPM
Torque ..............................................69.3 ft. lbs (94 N.m.)
Fuel type .........................Low or Ultra Low Sulfer Diesel
Air cleaner ...............................Replaceable Dry Cartridge
....................................................................w/ indicator
Maximum governed RPM (no load).................3000 RPM
Hydraulic System
Pump type ...................................................................Gear
Pump capacity.................................8.7 GPM / 3000 RPM
......................................................33 L/M / 3000 RPM
Control valve ............. Parallel type with float on lift and
.........................................................detent on auxiliary
System relief pressure (Zero Flow) ................... 2200 PSI
.................................................................... (151.5 Bar)
Filtration ............................................................. 5 micron
Hydraulic fluid .............................. 10W30 API Class, SJ
.....................................................20W50 API Class, SJ
Oil Cooler...............................250 BTU/min (264 kJ/min)
Engine Oil ...................................................5W40 API CF
Cylinders (double acting) Lift Tilt
Bore dia. 2 in. 2 in.
Rod dia. 1.125 in. 1.125 in.
Hydrostatic Transmission & Final Drive
Pump type .................................. Two in line, axial piston
Pump displacement ............................ 1.5 cu. in. (25 cm
3
)
Motor type ..................................... Geroler, torque motor
System relief setting ..........................3625 PSI (250 Bar)
Final drive ................................... No. 60 HT roller chain
....................................................running in an oil bath
Electrical
Alternator.....................................................................60A
Battery ........................................................................12 V
Type ...........................................................................34/78
Cranking amps..............................................................730
Reserve capacity...........................................................125
Starter..........................................................................12 V
Tires
Standard ....................................................8.50 x 15, 4 ply
Flotation ..................................................10.50 x 15, 4 ply
...............................................30 - 35 PSI (207 - 241 kPa)
Fluid Capacities
Fuel tank ..................................................11.3 gal. (43 L)
Final drive transmission ..........................5.9 gal. (22.3 L)
Hyd. Reservoir ................................................9 gal (34 L)
Engine cooling system ............................3.2 gal. (12.1 L)
Engine oil................................................1.6 Gallons (6 L)