DMS-CTC-20101208-0018 v1.0
21
Manual Installation
3 Manual Installation
Installation
This chapter will help you to manually install your Thomson Gateway.
Setting up your network
Proceed as follows:
1 Connect your Thomson Gateway to your service provider’s network.
For more information, see “3.1 Connecting the Thomson Gateway to your Service Provider’s Network”
on page 22.
2 Power on the Thomson Gateway.
For more information, see “3.2 Powering on the Thomson Gateway” on page 25.
3 Connect your computer to the Thomson Gateway.
For more information, see “3.3 Connecting Your Network Devices to the Thomson Gateway” on page 26.
4 Configure your Thomson Gateway.
For more information, see “3.4 Configure the Thomson Gateway” on page 29.
5 Connect your (DECT) phones
For more information, see “6 Telephony” on page 45.
6 Share your content or media on your local network, continue with “8 Sharing Content on your Thomson
Gateway” on page 65.
7 Once you successfully installed your Thomson Gateway, it is recommend to backup your configuration.
This will allows you to return to this configuration when needed (for example, after misconfiguration).
For more information, see “4.2 Backing Up/Restoring your Configuration” on page 37
To Next Page
Loading...
