THOMSON TG797n - Configuring the Thomson Gateway Voip Service

DMS-CTC-20101208-0018 v1.0
49
Telephony
6.1.3 Configuring the Thomson Gateway VoIP Service
Introduction
If your VoIP service has not been configured yet, follow the instructions in this section.
How can I check if the VoIP service has already been configured?
If the Phone LED is:
 Solid or blinking green then the VoIP service is configured correctly. No configuration is needed.
 Off then telephony service is not configured (yet). Follow the instructions below.
Requirements
Your Internet connection must be up and running before you can configure Internet telephony.
Configuring the VoIP settings
Proceed as follows:
1 Enter the proxy and registrar settings.
2 Enter your VoIP account settings.
Enter the proxy and registrar settings
Proceed as follows:
1 Browse to the Technicolor Gateway GUI.
For more information, see
“4.1 Technicolor Gateway GUI” on page 50 .
2 On the Toolbox menu, click Telephony.
3 In the Navigation bar, click Expert configure.
4 Complete the following fields based on the settings provided by your VoIP provider:
 Proxy:
Type the URL (for example: sip.provider.com) or IP address of the proxy.
 Registrar:
Type the URL (for example: sip.provider.com) or IP address of the registrar.
 Registrar Port and Proxy Port.
In most cases the default port (5060) will be used. Only change these values if your provider is using
other port numbers.
5 Click Apply.
Enter your VoIP account settings
Proceed as follows:
1 In the Navigation bar, click Configure.
2 Under Service Configuration, select Enable Telephony.
3 Under Telephone Numbers, complete the following fields: