DMS-CTC-20101208-0018 v1.0
38
Configuration Tools
4.3 Access From the Internet
Modes
To access your Thomson Gateway from the Internet, you can choose between two modes:
Permanent Mode (Remote Access):
The remote session ends when you disable remote assistance or after restarting your Thomson Gateway.
Temporary Mode (Remote Assistance):
The remote session ends when you disable remote assistance, after restarting your Thomson Gateway or
after 20 minutes of inactivity.
To enable Remote Assistance / Remote Access.
To enable remote assistance/access:
1 Browse to the Technicolor Gateway GUI.
For more information, see “4.1 Thomson Gateway GUI” on page 32.
2 Complete and check the following parameters:
Mode:
Select the mode that you want to use.
URL:
Contains the URL that must be used to access the Thomson Gateway from the Internet.
User name and Password:
Contains the user name and password are needed to access your Thomson Gateway remotely. If
wanted you can change the automatically generated password in the Password box.
3 Click Enable Remote Assistance.
Accessing your Thomson Gateway from the Internet
Proceed as follows:
1 Open your web browser.
2 Type the URL that was listed in the URL field on the Remote Assistance page (for example https://
141.11.249.150:51003).
3 Enter the user name and password that you specified on the Remote Assistance page.
4 The Thomson Gateway GUI appears.
It is now possible for a remote user to access your Thomson Gateway via the specified URL using the
provided user name and password.
Enabling remote assistance is only possible when you are connected to the Internet.
You can replace the IP address in this URL by the dynamic DNS host name if you enabled and
configured Dynamic DNS. For more information, see Dynamic DNS.
Example: https://141.11.249.150:51003 can be replaced by https://
mygateway.dyndns.org:51003.
To Next Page
Loading...
