DMS-CTC-20101208-0018 v1.0
47
Telephony
6.1.1 Connecting a DECT Phone to Your Thomson Gateway
Introduction
The Thomson Gateway is equipped with a DECT base station allowing you to connect up to five DECT
phones.
Before you can start using your DECT phone, you first have to pair it with your Thomson Gateway.
Procedure
Proceed as follows:
1 Put the Thomson Gateway in pairing mode. You can do either of the following:
Press the DECT button on the Thomson Gateway until the DECT LED on the front panel starts
flashing.
Via the Thomson Gateway GUI.
1 On the Toolbox menu, click Telephony.
2 Under Pick a task, click DECT pairing.
2 Put your DECT phone in pairing mode.
Consult your DECT phone’s user documentation to register your DECT phone.
3 Your DECT phone prompts you that If the registration is successful, the message “Registered to base x”
appears on the screen of your THOMSON DECT phone.
To Next Page
Loading...
