TSC 800 TRANSFER SWITCH CONTROLLER
PM 049 REV 10 08/09/25 Thomson Technology
42
7.2.2. AUTO TEST START DAY/WEEK NUMBER
Select the day of the week (e.g. Monday, Tuesday, etc.) and week number (e.g. 1-4)
that the generator set is to be started to begin its exercise period.
NOTE:
Week Number is programmable only if the System Time Clock
Rollover period is set longer than 7 days.
7.2.3. AUTO TEST START HOUR
Select the hour of the day (e.g. 0-23 hour) that the generator set is to be started to
begin its exercise period.
7.2.4. AUTO TEST START MINUTE
Select the minute of the day (e.g. 0-59 minutes) that the generator set is to be started
to begin its exercise period.
7.2.5. AUTO TEST STOP DAY/WEEK NUMBER
Select the day of the week (e.g. Monday, Tuesday, etc.) and week number (e.g. 1-4)
that the generator set is to be stopped following its exercise period.
NOTE:
Week Number is programmable only if the System Time Clock
Rollover period is set longer than 7 days. Ensure Auto Test
Stop Day/Week/Timer occurs after the Auto Test Start
Day/Week/Timer setting (Generally of the same day/week)
otherwise the generator may operate for an extended period of
time.
7.2.6. AUTO TEST STOP HOUR
Select the hour of the day (e.g. 0-23 hour) that the generator set is to be stopped
following its exercise period.
To Next Page
Loading...
