TSC 800 TRANSFER SWITCH CONTROLLER
PM 049 REV 10 08/09/25 Thomson Technology
2
1.2. GENERAL DESCRIPTION
The TSC 800 controller utilizes microprocessor-based design technology, which provides high
accuracy for all voltage sensing and timing functions. The TSC 800 is factory configured to
control all the operational functions and display features of the automatic transfer switch. All
features of the TSC 800 are fully programmable from the front panel LCD display and are
security password protected. The LCD display screen prompts are in plain English, providing
a user-friendly operator interface with many display options available. The microprocessor
design provides many standard features, which were previously only available as add-on
optional features.
2. INSTALLATION
CAUTION
contents subject to damage by
STATIC ELECTRICITY
This equipment contains static-sensitive parts. Please observe the following anti-static precautions at
all times when handling this equipment. Failure to observe these precautions may cause equipment
failure and/or damage.
• Discharge body static charge before handling the equipment (maintain exposed body contact
with a properly grounded surface while handling the equipment, a grounding wrist strap
can/should also be utilized).
• Do not touch any components on the printed circuit board with your hands or any other
conductive equipment.
Do not place the equipment on or near materials such as Styrofoam, plastic and vinyl. Place the
equipment on properly grounded surfaces and only use an anti-static bag for transporting the
equipment.
2.1. GENERAL INFORMATION
NOTE:
Installations should be done in accordance
with all applicable electrical regulation
codes as required.
To Next Page
Loading...
Need help?
General
