LEVELING AND SLIDEOUT SYSTEMS
70
7
CUSTOMER CARE | 877.855.2867
Slideouts provide expanded and roomy interior living space
LCI In-Wall
®
Slideout Systems
DO NOT MOVE OR DRIVE YOUR MOTORHOME WITH
SLIDEOUT(S) EXTENDED.
WHEN EXTENDING AND RETRACTING SLIDEOUT(S),
KEEP PEOPLE, PETS, AND OBSTRUCTIONS CLEAR
OF THE SLIDEOUT(S); BOTH INSIDE AND OUTSIDE OF
THE MOTORHOME.
DANGER
THE SLIDEOUT SYSTEM, WHICH CONSISTS OF
MOTORS, CONTROLLERS, AND RELATED HARDWARE
IS INTENDED FOR THE SOLE PURPOSE OF EXTENDING
AND RETRACTING THE SLIDEOUT ROOM OR ROOM
EXTENSION. ITS FUNCTION SHOULD NEVER BE USED
FOR ANY OTHER PURPOSE.
TO USE THE SYSTEM FOR ANY OTHER PURPOSE
OTHER THAN WHAT IT IS DESIGNED FOR MAY RESULT
IN DEATH, SEVERE INJURY OR DAMAGE TO THE
MOTORHOME.
WARNING
BEFORE OPERATING SLIDEOUT(S):
• Park on a level area and if installed with leveling
jacks or stabilizers, level or stabilize the motorhome
with the jacks in the down position.
• Ensure that children and pets are kept well away
from moving slideouts.
• Always inspect the area outside the slideout prior
to operating to safeguard that the slideout will not
contact nearby trees, vehicles, utility poles, or other
obstacles.
• Gear tracks present a severe pinch hazard; keep
hands away from moving slideouts.
• Ensure that the interior oor and space is clear of
any obstacles that could impede slideout travel or
become entrapped under the slideout or slideout
rollers.
• If equipped, remove travel bars or slide-locks prior
to operating slideout(s).
• Engage emergency (parking) brake and keep the
parking brake engaged while the vehicle is parked
and the slideout(s) is/are extended.
CAUTION
For slideouts that are located just behind the cockpit,
place driver and front passenger seats in the most forward
position and place the seatbacks in the upright position;
otherwise slideout may contact and damage seatbacks
and/or slideout motion will be inhibited.
When extending and retracting slideouts, you must maintain
pressure on the control button continuously while the
slideout is in motion. Avoid stopping and starting the
motors during slideout travel.
It is important to continue to press the slideout switch
for a few seconds after the slideout is fully extended
and until the motors shut off. The controller will sense
that the room has stopped and will shut the motor
off automatically. This operation keeps the motors
synchronized.
If the slideout motors are not synchronized, the slideout
will likely bind while extending or retracting. If binding
occurs, STOP OPERATING THE MOTORS; the motors or
gear tracks could be damaged. The slideout motors will
need to be re-synchronized and the slideout may need
to be manually retracted. Refer to the manufacturer’s
instructions for resynchronizing motors and manual
override instructions.
Routinely inspect the slideout awning for damage; it
provides important weather protection. Also ensure
the awning operates properly, extending and retracting
with the slideout.
NOTICE
DO NOT MOVE OR DRIVE YOUR MOTORHOME IF THE
SLIDEOUT MOTORS ARE DISCONNECTED FROM THE
SLIDEOUT CONTROLLER OR IF THE MOTORS HAVE
BEEN DISCONNECTED FROM THE GEAR TRACK.
If it is necessary to move the motorhome in these
conditions, secure the slideout with travel bars, slide
locks, or other means in order to prevent slideout
movement.
WARNING
To Next Page
Loading...
