Thor Motor Coach CLASS A - Extending the Slideout; Retracting the Slideout; Remote Operation

LEVELING AND SLIDEOUT SYSTEMS
72
7
CUSTOMER CARE | 877.855.2867
Observe the same safety precautions as previously stated for
slideout operation, and:
1. Be sure there are no obstructions on the oor of the
coach or in the path of the slideout.
2. Diesel Class A Motorhomes: Place motorhome’s trans-
mission in NEUTRAL and apply PARKING BRAKE.
Engine must be RUNNING for hydraulic-actuated
slideouts.
Gas Class A and all Class C Motorhomes: Place motor-
home’s transmission in PARK and apply PARKING
BRAKE. Engine must be RUNNING.
3. Turn the Master battery switch ON.
4. Locate the slideout operating switch (location varies per
model and oor plan). If the motorhome is equipped
with a multiplex system, the slideout control is located
on the slideout/awning (motors) menu screen. For all
other installations, slideout control switches are located
on the Monitor Panel.
5. Press and hold the OUT/Extend button for 3-5 seconds,
then press and hold the IN/Retract button until the
slideout is fully retracted. Continue to hold the IN/
Retract button for an additional 3-5 seconds, then release
the button (this action will help keep the slideout motors
in-sync).
6. Install the slideout locking devices (if equipped).
Remote Operation
Motorhomes with multiplex control systems may offer
remote control of slideouts, awnings, and other motorhome
functions via a smartphone app. Check with your dealer or
review the multiplex system manufacturer's instructional
guide for information regarding remote control features.
Retracting the Slideout
Before retracting a slideout, always visually inspect the
roof and awning of the slideout for any debris or damage.
Check the gear tracks for debris or damage. Check the
weather strips and seals.
Before moving the motorhome, always perform an interior
and exterior visual inspection to ensure slideout is fully
retracted, secured, and prepared for travel.
recommends plugging into shore power or operating the
generator while extending and retracting slideouts. is
will ensure the house 12 volt system has sucient power
to operate the slideout motors.
3. Keep the slideout motors in-sync:
Doing so ensures proper slideout operation. When
operating an electric slideout, always follow the proce-
dures described in this section. is will help keep the
slideout motors operating smoothly.
Extending the Slideout
Aer completing the exterior and interior inspections prior
to slideout operation:
1. Level the motorhome with leveling jacks or stabilize
with stabilizing jacks (refer to Leveling and Stabilizing).
2. Diesel Class A Motorhomes: Place motorhome’s trans-
mission in NEUTRAL and apply PARKING BRAKE.
Engine must be RUNNING for hydraulic and electric
actuated slideouts.
Gas Class A and all Class C Motorhomes: Place motor-
home’s transmission in PARK and apply PARKING
BRAKE. Engine must be RUNNING.
3. Turn the Master battery switch ON.
4. Locate the slideout operating switch (location varies per
model and oor plan). If the motorhome is equipped
with a multiplex system, the slideout control is located
on the slideout/awning (motors) menu screen. For all
other installations, slideout control switches are located
on the Monitor Panel.
5. Press and hold the IN/Retract button for 3-5 seconds,
then Press and hold the OUT/Extend button until the
slideout is fully extended AND hold the switch for an
additional 3-5 seconds, then release the switch (this
procedure helps to keep the slideout motors in-sync).
CAUTION