EasyManuals Logo

THORLABS DCC1645C User Manual

THORLABS DCC1645C
530 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #186 background imageLoading...
Page #186 background image
© 2013 Thorlabs GmbH184
DCx Cameras
hCam
Camera handle
IS_CONFIG_CPU_IDLE_STATES_CMD_SET_DISAB
LE_ON_OPEN
Changes the energy settings of the operating system so
that low power consumption operating states (unequal
C0) are disabled.
Additional information
pParam: Pointer to a UINT variable, see
CONFIGURATION_SEL .
nSizeOfParam: 4
Note: To apply a new setting, you must close all open
DCx Cameras and then reopen at least one camera.
Example 3
IS_CONFIG_CPU_IDLE_STATES_CMD_GET_DISAB
LE_ON_OPEN
Returns the current setting for
IS_CONFIG_CPU_IDLE_STATES_CMD_SET_DISABLE_
ON_OPEN.
Additional information
pParam: Pointer to a UINT bitmask. The status flags
from CONFIGURATION_SEL are returned in the
bitmask.
nSizeOfParam: 4
Example 3
IS_CONFIG_OPEN_MP_CMD_GET_ENABLE
Returns whether OpenMP support is enabled.
Additional information
pParam: Pointer to a UINT bitmask. The status flags
from CONFIGURATION_SEL are returned in the
bitmask.
nSizeOfParam: 4
Example 4
IS_CONFIG_OPEN_MP_CMD_SET_ENABLE
Enables OpenMP support.
Additional information
pParam: Pointer to a UINT variable,
to enable: IS_CONFIG_OPEN_MP_ENABLE
to disable: IS_CONFIG_OPEN_MP_DISABLE
nSizeOfParam: 4
Note: The settings are lost after the application is closed
and must be set again the next time the camera is
started.
Example 4
IS_CONFIG_OPEN_MP_CMD_GET_ENABLE_DEFAUL
T
Returns the default setting for OpenMP support.
Additional information
pParam: Pointer to a UINT bitmask. The status flags
from CONFIGURATION_SEL are returned in the
bitmask.
nSizeOfParam: 4
Example 4
IS_CONFIG_INITIAL_PARAMETERSET_CMD_SET
Sets the parameter set to read and apply from the camera
EEPROM when the camera is opened.
Additional information
pParam: Pointer to a UINT variable,
IS_CONFIG_INITIAL_PARAMETERSET_NONE
IS_CONFIG_INITIAL_PARAMETERSET_1
IS_CONFIG_INITIAL_PARAMETERSET_2
nSizeOfParam: 4
Example 5
IS_CONFIG_INITIAL_PARAMETERSET_CMD_GET
Returns which parameter set will be read and applied
from the camera EEPROM when the camera is opened.
185
186
185
186
185
187
187
185
187
187

Table of Contents

Other manuals for THORLABS DCC1645C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS DCC1645C and is the answer not in the manual?

THORLABS DCC1645C Specifications

General IconGeneral
BrandTHORLABS
ModelDCC1645C
CategorySecurity Camera
LanguageEnglish

Related product manuals