THORLABS DCC1645C - Is_Setbadpixelcorrection

© 2013 Thorlabs GmbH
4 Programming (SDK)
417
4.5.28 is_SetBadPixelCorrection
USB 2.0
USB 2.0
Syntax
INT is_SetBadPixelCorrection (HIDS hCam, INT nEnable, INT threshold)
Description
Attention
This function is obsolete and should not be used anymore. We recommend to use the is_HotPixel()
function instead (see also Obsolete functions ).
is_SetBadPixelCorrection() enables/disables the software correction of sensor hot pixels.
Attention
This correction will not work while sub-sampling or binning are enabled or raw Bayer mode is used.
Input parameters
hCam
Camera handle
nEnable
IS_BPC_DISABLE
Disables the correction function.
IS_BPC_ENABLE_SOFTWARE
Enables software correction based on the hot pixel list
stored in the EEPROM.
IS_BPC_ENABLE_USER
Enables software correction based on user-defined
values. First, the is_SetBadPixelCorrectionTable
() function must be called.
IS_GET_BPC_MODE
Returns the current mode.
IS_GET_BPC_THRESHOLD
Returns the current threshold value.
threshold
Currently not used
Return values
IS_SUCCESS
Function executed successfully
IS_NO_SUCCESS
General error message
When used with
IS_GET_BPC_MODE
Current mode
When used with
IS_GET_BPC_THRESHOLD
Current threshold value
Related functions
is_LoadBadPixelCorrectionTable()
is_SaveBadPixelCorrectionTable()
is_SetBadPixelCorrectionTable()
260
379
418
394
405
418