THORLABS DCC1645C User Manual

© 2013 Thorlabs GmbH192
DCx Cameras
4.3.15 is_DeviceFeature
USB 2.0
USB 3.0
USB 2.0
USB 3.0
Note
This command is supported by DCC1240x / DCC3240x cameras only!
Syntax
INT is_DeviceFeature (HIDS hCam, UINT nCommand, void* pParam, UINT cbSizeOfParam)
Description
Using is_DeviceFeature() you can configure special camera functions provided by DCC1240x / DCC3240x
Camera models:
Set line scan mode, see Basics: Line scan mode (only monochrome models).
Toggle between shutter modes, see Basics: Shutter methods.
Control the Log mode, see uc480 Viewer: Shutter.
The nCommand input parameter is used to select the function mode. The pParam input parameter depends on the
selected function mode. If you select functions for setting or returning a value, pParam contains a pointer to a
variable of the UINT type. The size of the memory area to which pParam refers is specified in the
cbSizeOfParam input parameter.
Input parameters
hCam
Camera handle
nCommand
IS_DEVICE_FEATURE_CMD_GET_SUPPORTED_FEAT
URES
Returns the functions supported by the camera. See
Status flags table (Example 1 )
IS_DEVICE_FEATURE_CMD_SET_LINESCAN_MODE
Sets the line scan mode, see
DEVICE_FEATURE_MODE_CAPS
IS_DEVICE_FEATURE_CMD_GET_LINESCAN_MODE
Returns the currently set line scan mode
IS_DEVICE_FEATURE_CMD_SET_LINESCAN_NUMBE
R
Sets the scan line used for the line scan mode
IS_DEVICE_FEATURE_CMD_GET_LINESCAN_NUMBE
R
Returns the scan line used for the line scan mode
IS_DEVICE_FEATURE_CMD_SET_SHUTTER_MODE
Sets the shutter mode, see
DEVICE_FEATURE_MODE_CAPS
IS_DEVICE_FEATURE_CMD_GET_SHUTTER_MODE
Returns the shutter mode
IS_DEVICE_FEATURE_CMD_GET_LOG_MODE_DEFAU
LT
Returns the default settings for the Log mode (Example 2
)
IS_DEVICE_FEATURE_CMD_GET_LOG_MODE
Returns the currect Log mode (Example 3 )
IS_DEVICE_FEATURE_CMD_SET_LOG_MODE
Sets the Log mode
IS_DEVICE_FEATURE_CMD_GET_LOG_MODE_MANUA
L_VALUE_DEFAULT
Returns the default settings for the manual value of the
Log mode (Example 4 )
IS_DEVICE_FEATURE_CMD_GET_LOG_MODE_MANUA
L_VALUE_RANGE
Returns the range of the manual value of the Log mode.
IS_DEVICE_FEATURE_CMD_GET_LOG_MODE_MANUA
L_VALUE
Returns the current manual value of the Log mode
(Example 5 )
IS_DEVICE_FEATURE_CMD_SET_LOG_MODE_MANUA
L_VALUE
Sets the manual value of the Log mode
33
30
116
193 194
194
194
195
195

THORLABS DCC1645C Specifications

General

Brand	THORLABS
Model	DCC1645C
Category	Security Camera
Language	English