THORLABS DCC1645C - Is_Setbayerconversion

© 2013 Thorlabs GmbH420
DCx Cameras
4.5.30 is_SetBayerConversion
USB 2.0
USB 2.0
Syntax
INT is_SetBayerConversion (HIDS hCam, INT nMode)
Description
is_SetBayerConversion() enables you to select one of two algorithms for the Bayer conversion. These
algorithms vary in the obtainable quality and in the required computer load.
Attention
This function is obsolete and should not be used anymore. We recommend to use the is_SetColorConverter
() function instead (see also Obsolete functions ).
Note
This function can be used only for the 24 bit, 32 bit and Y8 color formats (color cameras).
Input parameters
hCam
Camera handle
nMode
IS_SET_BAYER_CV_BETTER
Good quality, minor color artifacts, lower computational
load
IS_SET_BAYER_CV_BEST
Best quality and edge acuity, higher computational load
IS_GET_BAYER_CV_MODE
Returns the current setting.
Return values
IS_SUCCESS
Function executed successfully
IS_NO_SUCCESS
General error message
When used with
IS_GET_BAYER_CV_MODE
Current setting
Related functions
is_SetColorConverter()
is_SetColorMode()
is_SetColorCorrection()
315 379
315
319
317